MULTIPLE UNWINDERS
Possibility of adding 1 or more reels in-line.

ELECTRONIC REAM COUNTER
Device with tab-insert separator between the required number of sheets manageable by operator panel or separately.

PNEUMATIC REEL-LIFTER
System with independent control panel and lifting/lowering movement on the separate panel at unwinder side.

MOTORISED LONGITUDINAL CUTTING
Kit made up of circular blades and relative counter-blade on the millimetric sliding bar that provides precise blade positioning.

COLLECTION BELT
“Non-Stop”: Mobile collection belt with sheet pack movement by means of station movement. All servo-assisted and controlled
by PLC, from which the number of sheets and all parameters regarding the movement of reams of sheets ready to be packed can be set.

PANTOGRAPH STRIKE PLATES
Their pantograph shape not only allows them to be controlled remotely but also provides greater accuracy and less external
machine encumbrance. (THESE CAN BE MOTORISED OR MANUAL)

WEB GUIDE
This application enables to carry out the transversal alignment of two or more reels simultaneously. They can be equipped with floor-based plates with movement by means of bearings, or in compact mode, applicable directly on expansion axis support.

DOUBLE REGISTER CONTROL
Kit for the installation of a second photo-cell, which enables to carry out the simultaneous cutting of two reels with register control.

VELVET BELTS
‘ANTI-ROULING’ velvet transport belts for delicate materials (i.e.: Copy paper, etc.).

SHAFTLESS UNWINDER
‘Shaftless’ unwinder with pneumatic reel lifting, self-centring and alignment of reels, to reduce down times caused by the loading of new reels, and unloading of used cores. This device also reduces operator accident risks caused by the lifting of expansion axes.

RAISED CUTTER BASE
Base to raise the machine which allows to obtain a higher stack of cut sheets, made up of a sturdy iron frame and an external platform with safety railing to reach machine/operator control panel.

DANCER CONTROL
System required for the combination of the cutter with other machines via electronic and mechanical interface.